How to Extend Your Toy Track with the 60° Turn Expansion Pack
By Kids and Baby Clothes Rompers, T-Shirts, & More |RAGS.com .... | Published: 2026-10-31
Category: How-to Guides
Add sweeping curves to your Roadworks layout with the 60° Turn Expansion Pack. Follow these steps to plan, assemble, and test a two-lane curve that keeps play flowing.
Quick answer
Use the 60° Turn Expansion Pack to add two lanes of sweeping 60-degree curves to your existing Roadworks track. Plan the curve direction first, connect the pieces with the BoneLock system, and test with a car before locking down the rest of your layout.
Why a 60° curve changes your layout options
A 60-degree turn is gentler than a sharp corner, so it lets cars carry more speed through the bend and opens up designs like wide loops, S-curves, and return lanes. The pack adds 2 ft (60 cm) of two-lane track, enough to reshape a straight run into a flowing curve without rebuilding everything.
Because it is a pair-to-play set for X3, it works as an add-on rather than a standalone track. Check that your base set uses the same connector system before buying.
When this pack is not the right upgrade
If your layout already has tight corners or you need elevation changes, a different add-on kit may suit you better. This pack focuses on flat, wide turns; it does not include cars, playsets, or supports. Also, if you are still deciding on a first track, start with a core set and add curves later.
Steps to add the 60° Turn Expansion Pack
- Map your current track: Lay out your existing Roadworks track on the floor and mark where you want the new curve to go. Decide whether the turn should go left or right from the driver's perspective. Common mistake: picking a spot without checking that the curve will not block a straight section you still need. Use painter's tape to outline the curve's footprint before connecting anything.
- Connect the first curve piece: Align the BoneLock connectors on one end of the 60° turn with the matching end of your straight track. Push until you feel or hear the lock engage. Checkpoint: give the joint a gentle tug; it should hold without wobbling.
- Add the second lane: Repeat the connection for the parallel lane, keeping the two lanes evenly spaced. Common mistake: forcing a piece in at an angle, which can strain the connectors. If it resists, lift the piece and realign. Run your finger along the inside edge of both lanes to feel for gaps or misalignment.
- Complete the curve and test with a car: Connect the far end of the turn to your next track section. Place a car at the start of the curve and roll it through by hand. Checkpoint: the car should pass without catching on joints or rubbing the outer wall. If the car slows sharply, recheck that both lanes are fully locked.
- Lock down the full layout: Once the curve works, connect the rest of your track and run a full lap. Adjust any loose joints before high-speed play. Common mistake: leaving the curve as the last piece to connect, which makes it harder to align the rest of the track. Do a final walk-around to confirm no connectors are exposed or half-engaged.
Product facts
- Expansion Pack: 60° Turn: Two lanes and 2 ft (60 cm) of 60° turns; this is an X3 pair-to-play set. It doubles your track width for side-by-side racing and adds a measured curve length you can plan around.
Expansion Pack: 60° Turn - Expansion Pack: 60° Turn: Uses the patent-pending BoneLock connector system for easy assembly and breakdown. You can test different curve placements without damaging pieces, which makes layout experiments faster.
- Expansion Pack: 60° Turn: Cars, playsets, and add-on kits are sold separately. You will need an existing X3 track and at least one car to use the pack, so factor that into your purchase.
